Intel Ethernet Controller products

Intel Corporation 82545em Gigabit Ethernet Controller Linux Driver

Intel corporation 82545em gigabit ethernet controller linux driver

Allows Phy to turn off in lower power states. Instead, use the Speed and Duplex parameters previously mentioned to force the adapter to the same speed and duplex. The parameter may be specified as either a decimal or hexadecimal value as determined by the bitmap below. If you require a response, contact support.

Downloads for Intel 82545EM Gigabit Ethernet Controller

After installing the driver, if your Intel Network Connection is not working, verify that you have installed the correct driver. For questions related to hardware requirements, see the documentation supplied with your Intel Gigabit adapter. As the issue addressed by this parameter has never been observed on Intel Architecture platforms, it should not be used on Intel platforms. Intel is not supplying patches against the kernel source to allow for static linking of the driver. For questions related to hardware requirements, where to get mv-285 driver education certificate refer to the documentation supplied with your Intel Gigabit adapter.

Linux Base Drivers for Intel Ethernet Network Connection

If the system is reporting dropped receives, this value may be set too high, causing the driver to run out of available receive descriptors. Allows changing the interrupt mode at module load time, without requiring a recompile.

Download INTEL 82545EM Gigabit Ethernet Controller Drivers

There are no workarounds for this problem in this network configuration. This value coincides with the maximum Jumbo Frames size of bytes. There is a known issue using Jumbo frames when connected to a Foundry BigIron switch.

Proper tuning, along with RxIntDelay, may improve traffic throughput in specific network conditions. To eliminate the potential for the hang ensure that RxIntDelay is set to zero. Install the ee driver using the instructions in the ee section.

All hardware requirements listed apply to use with Linux. Many popular Linux distributions ship with tools to make these changes for you.

It should be used when you wish to control which speed and duplex combinations are advertised during the auto-negotiation process. WoL will be enabled on the system during the next shut down or reboot. The install location listed above is the default.

Identifying Your Adapter

If during this process you are asked for the driver or module name, the name for the Linux Base Driver for the Gigabit Family of Adapters is igbvf. If during this process you are asked for the driver or module name, the name for the Linux Base Driver for the Gigabit family of adapters is ee. After installing the driver, if your Intel Ethernet Network Connection is not working, verify that you have installed the correct driver. In addition, the controller is automatically reset, restoring the network connection. This is caused by the way the Linux kernel reports this stressed condition.

Download INTEL 82545EM Gigabit Ethernet Controller Drivers

If you have just recompiled the kernel reboot the system now. Verify that the interface works. This script will verify that the adapter is applicable to the fix and if the fix is needed or not. This enables the problematic power saving feature.

The default value for each parameter is generally the recommended setting, unless otherwise noted. This parameter is supported only on adapters using copper connections.

Intel Ethernet Controllers

TxDescriptors This value is the number of transmit descriptors allocated by the driver. These drivers are only supported as a loadable module. This driver is only supported as a loadable module at this time. The hardware can handle many more small packets per second however, and for this reason an adaptive interrupt moderation algorithm was implemented. The AutoNeg parameter is used when more control is required over the auto-negotiation process.

Identifying Your AdapterLinux Base Driver for Intel Gigabit Ethernet Network Connections